Placed order, it came shortly afterward, easy to install and works great! I would recommend it to everyone!

this thing puts out an incredible amount of warm air heat. Last winter we hadn't set up the ductwork to the rest of the house yet so we just let all of the warm air going to the basement without the plenum installed. We have a two story wood frame house. there was more than enough heat coming naturally rising from the basement through the vents for the unattached duct work to keep the whole bottom floor warm, and still will a lot of heat going to fill the stair well going upstairs.

One thing I would have done different would have been to have had dryer wood. Ideally, you need to have wood properly stacked with air spaces between the stacked piles and covered at the top to keep the rain off TWO summers before you need it. You want the wood at less than 20% moisture. 15% if you can possible get it that low. Sure it will burn with more, but remember, that extra moisture in the wood wastes heat. First, you need MORE fuel just to be able boil off that moisture. Second, the loss of the heat going to boil off the moisture reduces the temperature of the flame, leading to incomplete burning of gasses (an extra waste of heat), with the unburned residue going up your chimney, coating the chimney walls as they condense into liquid (tar) form as they lose heat. maybe watch this video a few times to learn how to stack wood. leave an air spece between the rows. https://www.youtube.com/watch?v=pQfBffmDpRs

Was shipped fast, packaged great. These people just gets it done. Thanks for the great, fast service.

This wood furnace drawls really good. It holds a fire for a long

this is a very heavy appliance. be prepared for when it is delivered. Rent a couple of heavy duty appliance dollies, and to move it from the the sidewalk to our walkout basement we had to put down pieces of plywood to roll them over because our driveway and walkway are not paved. It will be a tight fit getting it through a 32" door opening. I had to take the door off and even take the door jamb molding off to get the pallet through. There are a couple of protrusions on the pallet to accommodate the shipping box that you will want to saw off with a small hand saw. Once you get it to the place you want to install it, to lift it off of the pallet there is a metal loop on the top of the unit that can be used to lift it from using a ratchet cable winch that you can also rent, but you'll have to put in a bit of temporary framing in the floor joists overhead to have a place to lift it from. Waited too long in the season to order this, so of course when I got the firewood the moisture content was way too high to even think about burning this year. Don't even think about burning wood that is 20% or over. You might as well try to burn gasoline in your car that is over 20% water. Buy yourself a moisture meter. Again - don't burn wet wood. Will let you know when I do fire it up as to how it works.